Les_Garten Posted May 5, 2010 Report Posted May 5, 2010 I have some of these Chinese "CMC" type RCA Jacks. They have a knurled ring that has indents for some type of PIN wrench. What do you guys have for these to keep them from getting scratched up via pliers? PIC
Pars Posted May 5, 2010 Report Posted May 5, 2010 I just finger tighten them, or use needlenose pliers in the notches. Or put a rag around the knurl and use channel-locks. I believe they do make a wrench for them though.
Les_Garten Posted May 5, 2010 Author Report Posted May 5, 2010 I tried that a little on a set that was installed on my DAC, and they were put on pretty tight, so they must have used some pin spanner or something on them. Not a single mark that I can see?
Pars Posted May 5, 2010 Report Posted May 5, 2010 RCA-805-Tool Audio Catalog only $28 (plus shipping from SE Asia)...
Les_Garten Posted May 5, 2010 Author Report Posted May 5, 2010 RCA Socket! Go figure! Thanx, that vendor always has interesting stuff.
Les_Garten Posted May 5, 2010 Author Report Posted May 5, 2010 Gets a little more expensive if you brand it a little apparently... WBT 0299 (ea.) RCA Socket Wrench Check this out for added fun! Look over the individual PIX http://www.worthpoint.com/worthopedia/vintage-rca-fingertip-wrenches
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now