Jump to content

[Review] Terminator pure class-A fully discrete soild state amp


033067

Recommended Posts

Specs

Pure class-A, with 20W power draw at idle

16-600 Ohms load (optimised for low impedance)

1700mW into 40Ohm load

W 184mm,L 300mm,H 56mm

2.2 KG

Sorry for blurry pictures, it is taken from my phone.

image-F8A6_4B8E8C2F.jpg

image-A4B3_4B9019A2.jpg

Better internal shot from the builder:

20091214_7594e50dcb024d8700f3Vssl2nK6bxMD.jpg

(the transformer is shielded in a metal case as seen in my photo)

Exterior

The amp is cased in a thick chassis and finished with thick brushed silver front panel. The volume control is metal with texture on it to prevent slipping. Rear of the amp have standard IEC power socket and a pair of RCA inputs. The RCA sockets are gold plated and bolted to the chassis, not direct stressing the PCB. The overall finish is very nice and solid, but to point out the

Link to comment
Share on other sites

I guess no one is taking it seriously but I'll post it anyway.

Soundstage

Certainly one of the strengths of this amp, the stage is very natural and open but not artificially large, positioning is very precise.

Detail

This amp shows very good detail, but due to the sound of the AD1000PRM which like amplifying the sound of micro details, it can be a bit tiring to listen with tonnes of different sound getting thrown in your face (ears I meant).

Highs

I would think this is the weak point of the amp. While the treble does extend quite well, the cymbal hits are not as sharp and clearly defined as I would like, certain much room for improvement.

Mids

Mids are abit smoothed out, which pair AT with forward mids quite well, however some might want to keep the forward mids and should not get this amp. Have said so, the mids are still overall forward, but just not as forward as before so the AT house sound is still here.

Bass

Bass is not boasted to add much addition warmth to the headphones, but the impact is plentiful, very tight and controlled too. It can go deep too but as the same, the sub-bass/low bass is still not boasted.

Speed

This amp is fast, and it helps to pair it with fast headphones, it never struggle in complex sections and every tone is clearly played without any blurring at all.

Strength

Natural and spacious soundstage, very good speed, good bass response, midrange (personal choice), price

Weakness

Treble can be better, midrange (personal choice)

Other flaws

The gain is quite high when using with my AD1000PRM, with my source at 100% the amp need to be turned right down. It doesn’t help at all with a sub-par volume pot, it just makes the matter worse as there is signifiecnt channel imbalance until it is over 8 o’clock range. This forces me to turn my source down to 25% to have some better control over the volume.

Equipment Used

Headphones: Audio Technica ATH-AD1000PRM, Ultimate Ears triple.fi 10 (Null Audio Enyo Silver + Sony Hybrids)

Source: Asus Xonar Essence ST (3 X LME49720HA)

Interconnect: Chord Company Crimson Plus RCA interconnect

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.