n_maher

You clearly don't get it. When asking any question it helps to know your audience. Very few of us around here use ALO cables and those that do know enough not to spend $250 on a LOD.

I lied, one more question, Zach. How far do they project from your ears? Bascially I'm looking for something that is a lot more flush than the ER4Ps and it looks the Freq's cable comes out at a bit of an angle and that has me curious.

You're really gunning for the Sr. title, aren't you?

I'm mad, but not quite that mad. I don't think you'll catch me doing 4-wire resistor matching any time soon.

You sure this isn't just bad static electricity?

And I also can't figure out how there would be high-voltage carried by the IC ground that wouldn't seriously f things up.

I can't think of a good way for you to test if the amp is the issue without potentially shocking yourself again so I'm hesitant to offer more advice right now...

Oh, I figure I'll be contacting you about something soon enough. I've got a certain email into Apogee...

Dude, that's f'ed up.

I know, it can't last.

I had a little bit of free time today so I decided to undertake the tedium that is matching all of the resistors for my balanced beta22. I guess this now officially qualifies as my next project.

That's good news, I was only hoping that it wouldn't be worse.

How's the isolation compared to the Etys, Zach?

Do the snow tires, Haj and get them somewhere local that will work the seasonal changeover into the price so that you don't need a spare set of rims. I went out and picked up gas for the snowblower today. We're forecast to get somewhere between 12 to 16" overnight and tomorrow. Yikes.

You need snow tires, Haj. My wife's Civic was god-awful in the snow until we equipped it with proper tires. And we didn't even go with studs, just standard snows.

If the ground pin is somehow lifted it might be possible for it to be part of the problem. I still don't understand why you've got voltage on the chassis to start with though.

Hey, if you want to opamp roll to try and mask another problem that's fine by me but unless you change the opamp to something that rolls off the treble or otherwise causes the amp to not have its ruler-flat frequency response I'm just saying I don't think you'll hear a substantial difference in the overall presentation. The M3 is a very resolving amp, you've probably never had one like it, so now you're finding that some of your other components are not its equal.

First place I would look is by the AC power switch.

If it were me I would not try to solve a problem that doesn't exist yet. You like the E500/530, have essentially a brand new pair, and I'd bet that Shure will treat it like your warranty reset with the new headphones. I see no reason to buy or sell anything.

My guess is that the M3 is not the problem or part that needs tweaking if you're finding things too bright.

Amphion Ions, which I quickly found out are a touch expensive for computer speakers. At least for me they were. edit - Mike beat me to it, but didn't provide a link so I chimed in anyway.

Don't think that one hasn't been priced. The problem is that getting raw aluminum panels, machining them and then sending them out to be anodized is so far completely cost prohibitive.

Yes, and they also made the "Hertsens" badge as well. You'll see similar things from me in the future.

You should ask FPE if they can handle material thicker than 4mm, then you can just buy the panel from Hifi2000 and send it to FPE for fabrication. They allow you to send the material to be modified, I do know that for sure.

Nah already done the 325s, time to try something different so it's 225s this time.