justin

w00t

that's no problem, i know someone in the business of fixing R10s

A few times I have started soldering on the AC input connections...while a cable was plugged in. Try it, see what happens

oh, i've made this before. Just leave milk in a cereal bowl for a week

Paid $35 here

^ part of that could be differences in size of the output capacitors (if any) on DAPs. a 47uF output capacitor, with the 13 ohm impedance of the UE10 - and I don't know specifically what the impedance is for low frequencies - would mean it starts rolling off below 260Hz.

why not go all-out, put a custom cable on with a 4-conductor mini plug and do it balanced. its too bad they're not 4 wires to the plug or that would be real easy

It only means 24/96 is the highest supported rate. 16/44.1 will stay 16/44.1

how would you separate the wood and metal cups?

Just got this and cracked it open. It has a SOIC-8 chip inside, with pins 1, 2, 6-8 soldered. Could it be a real apple authentication chip?

YTMND - Scootin' Dirty

is this the same thing?

fixed

Just read Todd's post; I guess if they had already built all the headphones, it would be a tough call, knowing they will probably sell all 500 anyway. But if the cups are just sitting there at Grado and they're going to continue using them that's messed up.

It would have been such an easy fix if only the headphones weren't assembled. Strip off the anodizing - lot charge of $25 Turn the faces of the cups again - less than 5 minutes per pair Anodize again - $1 per cup Then laser etch company does the whole job for free if they were the ones that screwed up I think it's most likely that the cups were taken in and assembled by people at Grado who do not know about Head-Fi and wouldn't have noticed the error. You could even just do a half-assed attempt to change the "1" to an "I"

more discrimination against people with longer 2nd toes

Just checked. Peeing in the sink is not going to happen However I could pee in the cabinet under the sink

I have one of the first 20 and there's nothing wrong with the engraving.

This is why the new woodies are buttonless, John wanted to use the centers for keychains

I bet those are "Mods". The op-amps and some capacitors for the DAC I/V stage have been removed. Likely replaced with a passive resistor I/V. You can see some of the holes for the capacitors still have solder in them

they have that, its called an HE90, start saving!

i would think that the owners of the songs (record labels) get the royalties and then if any is distributed to the artists it would be based on their contracts?

could be its also on the headphones so dont throw them away, bad for environment!

Anyone else notice the graphic symbol on the HD800 that says not to put them in the trash?