sbelyo

craptastic! Thankfully it's 39F with no precip here

I'm wiring up (or getting ready to) a 2 box Dynahi build and a new Buffalo III pro build. If I read the Rane article, the Tortuga article, and this post correctly I should connect IEC inlet ground to the chassis, Pin 1 of each XLR to the chassis, and PSU ground to the chassis for each box, then float the pot grounds in the Dynahi amp box. Is that correct?

Thanks Pars... I sent the diyaudio person a PM. There was a US seller on ebay that had them listed for a while now and of course hasn't relisted them in a month. I'll see what happens

is there a reliable source for 2SJ109BL ? I need 2

no sweat man... Merry Christmas!

yeah, I eventually found that... I'll see what I can cobble together

definitely check the offset on that thing. Not sure how good this would sound probably need to do something like this http://www.dms-audio.com/power-amp-heaadphone-adapter I'll work for a bag a chips and a cold beer

If I take say 1 120 Ohm 5 watt wire wound resistor for each channel that's sufficient for a dummy load correct?

Got it... Thanks for the schematic Chris. It's the 200K resistors. The cap has to increase to 5 pf

I need to make sure what resistors are the feedback for gain. Are they the 10K or 200K on either side of the input?

looks good

good, no magic smoke

Yeah, voltage seems ok. I'll go ahead and put it under load to see if it drops below the voltage that it should be

it did, I thought I had a very small fuse in there. Put a bigger one in and it held

OK, so I did something stupid and accidentally shorted the secondaries of an Avel Lindberg Y23 transformer for two seconds. The voltage seems fine after I corrected the error. Do you think it survived, and or what's the harm in using it?

loved that show... it's on sometimes daily where I am

lol, yep. Luckily I work from home. The cars were already encased in at least a half inch of ice while I was untangling the cord

Sucked up an extension cord into my snow blower... FVCK. Spent an hour untangling it, went to pull start it and the cord won't recoil now. Had to drag it back in the garage. I'm mad now! Snow is stupid... At least the driveway was clear when my wife came home from work

got it

Thanks for the schematic! When I look at the board JP1 seems to be in the mix. Can you tell if I have to close JP1 to use U2? Looks like this is the part number I need for U2 LT1021DIN8-5#PBF

glad it all arrived! perhaps this was your mail man

Very cool, thanks for looking at it. I'm going to build it and run it without a crowbar circuit for now until I can figure out what circuit to use. I asked for the schematic btw and they said no

Both Craig and Kevin made a good point that I failed to see. If any of the regulators let go it will send unwanted high voltage upstream. Does anyone know if there are some crowbar circuit pcb's out there? There's plenty of circuits I see on the web but not sure what to use.

Anytime...

my pleasure