eggil

They are both connected anyway. I get not even a hint of hum or noise if I briefly max out the volume trying to hear noise without music

Wiring looks good. This is how I did my second built and it is dead quiet.

S_R, do you have an extra amp board? I have a couple of LilKnights that went unclaimed. You could pay him if you need one and I could ship it to you. The wiring looks good from your picture but details are hard to see.

Sexual orientation, or gender or race should not be an issue for anybody. About time. For what I have seen, the more obsessed people are with abortion and gays, the more deviant they can be. Now, I would love to see a woman as president or pope

That is a beautiful set up you have there! How do you like our new DAC?

Are the balance and offset pot in the middle?

What is the voltage on the + and - outputs?

That really sucks! Could you describe what happened? Yours had been running longer than my off board build.

This one is a latching switch. No need for the e24. The frozencpu I currently have gets s tuck in the on position. The one I ordered is 117-MP0045/1E2BL012 from Mouser.

Thank you ! I am waiting for a Bulgin from Mouser, as well as the male XLR chassis mounts from Markertek for the loop outs.

Well, Bach and Jack Johnston came to life through my new KGSSHV. Wiring is what distinguishes the pros from the amateurs, and much as I try, is hard to make it as neat as some of you guys. Couldn't be happier though. Nothing blew this time. I kind of missed the fireworks from my first build The off board build was more challenging, this one was easier and looks nicer. Lots of thanks to Kevin and Birgir. Megatron, here I come!

Hey, that's very nice.

Those are expensive circles! Has anybody had any problems with frozencpu's latching switches? I have used 2, and both sometimes get stuck in the on position. If I tap it, it seems to fix the problem, but I am now concerned about reliability.. Certainly they are easier to deal with than the momentary switches, which need a relay.

Thanks Justin. Never seen those.

Yeah, it would help if I read the label that says "front".

LOL. I hate to be 100% wrong. 90% is OK, but 100%? Thank you Birgir

I have never played with an arduino; I guess I may have to sooner or later.

Thanks. Will look for a male XLR with screw in slots. I'll be using the alpha pot with Spritzer PCB.

I may be interested since I missed on the last run. Can you remote control them?

I had some issues with the casing, since fixed (kind-off), but haven't had time to finish it. Just hope I don't have an early 4th of July when I reconnect the wires. The Stax jacks are for Justin's jacks. Wiring is like Spritzer, or similar. The letters in the back are too big for my taste, but don't feel like writing another 90.00 check to FPE. I may though, when my wife is not looking. The only amp I currently have is not even an amp: SRD7Mk2. I know, the IEC is cheesy, but have not received the new one yet.

and that is why I paid attention to your posts and use lots of kapton tape. Better safe than sorry Just hate troubleshooting, harder than stuffing.

I really don't think there is a problem with the boards. My second build is going very well and without any trouble ( fingers crossed) but I am very OCD and triple check ( or more) every step and every solder.

Yes, both ugly...

Thanks jwzhan, I think you are right. Thanks deadlylover. I'll PM you then

I sent my panels to FPE for engraving. They received them but are asking me which side is up and which is down. Is this correct? I don't think it matters but I don't want to screw up.